March 26, 2004

Acorn Die

acorn_die.jpg This was so quick, dirty and effective that I just had to write it up 1. Roughly form acorn from 3/4" stock using a belt sander. 2. Mash it between 2 pieces of hot 3/4" x 1" welded at the other end. 3. Quench. 4. Heat some more 3/4" and bash it good in the die, rotating until it's mostly round. acorn_railing.jpg Posted by Hal Eckhart at March 26, 2004 08:06 AM | TrackBack
Comments
Post a comment
spam and annoying comments will be deleted







Remember personal info?




enter this number security code in the box below (prevents comment spam)